When I open a new doc in PSE3, why doesn't the doc line up with the zeros on the ruler. I never really saw this as a problem until I started to do digi scrapping. I have tried clicking on the cross hairs and moving the lines around - it always seems hit or miss as to where the doc ends up. I can usually get one corner to end up at zero, but then if I try to get the other one, it messes up the first one. When I hover over an area,(say the very upper left hand corner) the little cross hair on the ruler says that I am at Zero inches. But visually looking at the doc, the corner looks like it is at negative 1 or 2 inches. Do I have a glitch with elements?
Thanks - Dawn
Here is a screen shot:
Thanks - Dawn
Here is a screen shot: