What I'am doing wrong that I can't get to see the circle only a cross hair when I select the clone stamp in both Elements and CS3?

You may have the Caps Lock on.

Juergen

Don Diego, check to see if you have your cap locks on. That is usually the problem

Don, how annoying. I agree w/Juergen and Suzi. That caps lock will mess you up Good luck.

Yep,you all are 200% right. I was goig nuts, muchas gracias amigos.

De nada.

Juergen

Don,
it's possible to set the Caps Lock key to beep when pressed.
In Vista you have to go Ease of Access Centre and find toggle keys.
Setting this has saved me from not knowing that Caps Lock was on quite a lot.
Kev.

I have a keyboard that has a little light on the cap key that comes on when pressed. It sure helps with trouble shooting.

Wow, this is good information! I have had the problem occasionaly and did not understand why. I would finally resort to closing everything down and rebooting my computer, which fixed the problem, but I did not realize a simple Caps Lock Key was the root cause. Of course, rebooting brings the computer back on line with the Caps Lock off, hence the problem was solved, abeit the hard way.
Thanks,
Joe

Now I have been printing since 7am this morning and now is 11:56pm, time go fast but prints go slow,LOL.
What I discovered is that when i use the bamboo tablet the Caps Lock must be on in order to see the circle and not the cross hair. But when using the regular mouse and key boad the caps has to be off for me to see the circle and not the cross hair. Weird. All day